" />

vShooter Vibration Analysis Camera

The VShooter is a powerful “ALL IN ONE! portable device for your machine condition Analysis.

vShooter Vibration Analysis Camera VB1ST

vShooter Vibration Analysis Camera VB1ST

The VShooter is a NEW INNOVATIVE Diagnostic Tool for preventive maintenance.

The VShooter is used for fault detection in rotating equipment (fans, motors, pumps and gearboxes, etc,….). Unbalance, misalignment rolling element, bearing faults and resonance conditions can all be detected with the VShooter.

On the MCP, MACHINE CONDITION PICTURE, you are able to read the measurements and see the colour coded condition of the machine, which is fused within its picture.

ISO Velocity Vibration, Bearing conditions, Temperature, Speed and all detailed information shown in the MCP.

vShooter Vibration Analysis Camera VB1ST

vShooter Vibration Analysis Camera VB1ST

VSHOOTER® Delivery Pack :

  • VSHOOTER® device
  • Carrying strap
  • Universal Power Charger 230V-50Hz/60Hz > 5V/2A
  • USB cable for PC connection
  • ICP accelerometer 100 mV/g with flexible cable and BNC output
  • Strong flat magnet for accelerometer
  • Strong ABS case
  • Instruction manual
  • Calibration & Manufacturer certificate

VSHOOTER® accelerometer:

vShooter Vibration Analysis Camera VB1ST accelerator

vShooter Vibration Analysis Camera VB1ST accelerator

  • VSHOOTER® accelerometer:
  • Robust ICP sensor with strong flat magnet
  • Sensitivity of 100 mV/g (real sensitivity is set in the device)
  • Flexible cable 0,5-2m with BNC output
  • IP68
  • F response: 0,5-14.000 Hz (±3 dB)
  • Dynamic range: Max 80g
  • Max T°: 120°C (Continuous)
  • Delivered with certificate (Sensitivity)
  • Calibration check: 5g@160 Hz

VShooter Front Face with an MCP

vShooter Vibration Analysis Camera VB1ST

vShooter Vibration Analysis Camera VB1ST

VShooter Rear Face

vShooter Vibration Analysis Camera VB1ST Rear Face

vShooter Vibration Analysis Camera VB1ST Rear Face

MCP of a Motor Pump

vshooter14

Using VShooter at pump

vshooter 10

Taking Measurements of pump using the VShooter

vShooter Vibration Analysis Camera VB1ST

vShooter Vibration Analysis Camera VB1ST

VSHOOTER® MEASURED PARAMETERS (Metric/Imperial):

OVERALL VALUES:

  • A (g) in RMS from 1.000 to 10.000 Hz (0,01 to 49,99 g)
  • CREST (0-P/RMS) from 1.000 to 10.000 Hz (0,1 to 49,9)
  • V (mm/s) in RMS from (2)10 to 1.000 Hz (0,1 to 99,9 mm/s)
  • D (µm) in P-P from 2 to 1.000 Hz (1 to 9999 µm)
  • T° from 0 to 150°C with non contact infrared pyrometer
  • SPEED from 60 to 30.000 RPM (1Hz to 500 Hz) with LEDs stroboscope
WordPress SEO fine-tune by Meta SEO Pack from Poradnik Webmastera
Optimization WordPress Plugins & Solutions by W3 EDGE